A bathtub was used to simulate the pool. Six 1300-lumen floodlights were used to simulate the sun. Three small DSPH disks were made. Each was made of black nylon fabric stretched over a steel ring and then fitted with 3 buoy sticks to allow the disk to be suspended at the desired water depth. Two temperature probes were connected to a Vernier LabPro and a TI-83 calculator to collect temperature data at 2 different depths. Four experiments were conducted under controlled room and water temperatures. Each experiment lasted 12 hours and temperatures were recorded at 30-minute intervals. The 4 experiments were: 1)light and DSPH, 2)light but no DSPH, 3)no light but DSPH, and 4)no light and no DSPH.
Experiment 1(with light on and with DSPH) yielded the biggest temperature increase (+1.071C). This confirmed my first hypothesis that a pool of water with the DSPH in place will warm up to a higher temperature than the same without the DSPH. By comparing the data of experiments 1 and 2(with light on), it was noted that the surface water temperature was higher by 0.221C on average and the deep water temperature was higher by 0.169C on average when the DSPH was used. This confirmed my second hypothesis that the DSPH heats up the surface water more than the deep water.
My project demonstrated the feasibility of DSPH. I believe DSPH has many advantages over conventional solar or natural gas pool heating systems. DSPH is cheap to make, install, and maintain. It does not require electricity or natural gas to operate. It is also highly efficient with no heat loss due to pipes or heat exchangers. If DSPH is widely used, I believe it can reduce our energy consumption and lessen the chance of another energy crisis in our future.
The Direct Solar Pool Heater is a new invention designed to absorb solar energy using submerged black fabric disks and to transfer the absorbed energy directly to the pool water.
Science Fair Project done By Nicholas Fung